Lietuvos BMW Klubas

O kada tuomet pakaitina zvakes?

Šitie varikliai kaitina žvakes pagal tam tikrą algoritmą, kuris man rodos jau buvo čia aprašytas

Function

The glowplug control unit communicates with the DDE control unit via the bit serial data interface.

The required heating output is determined by the DDE control unit on the basis of the following operational parameters:
•Coolant temperature

•Vehicle voltage


Two other operational parameters determine the point at which glowplug function is activated and deactivated:
•Engine speed

•Injection volume


The DDE control unit transmits the heating request to the glowplug control unit via the bit serial data interface. The glowplug control unit puts the request into effect by activating the glowplugs by means of a pulse-width modulated signal. In addition, the glowplug control unit sends diagnostic and status information back to the DDE control unit.

Preheating

At coolant temperatures below 25 °C, there is a preheating period of 0.5 seconds. The preheating period increases as the temperature falls, reaching a maximum of 2.7 seconds at a coolant temperature of less than -25 °C.

Activation of the glowplug system on the instrument cluster only occurs at coolant temperatures below 0 °C.

After-heating

At coolant temperatures below 30 °C, there is a temperature-dependent after-heating period to improve idling and exhaust emission characteristics.

Start preheating

Start preheating takes place for approx. 10 seconds if after the preheating time has elapsed the engine is not started and the ignition remain on.