Lietuvos BMW Klubas

Kad nors kiek normaliai kazka daryt su inpa reikia tureti tris jos versijas. Su viena prapulsi.

IFH-0003: Data transmission HOST/Interface failed
Reason 1: In the Ediabas.ini file, the interface is set to STD:OBD. However, you have
connected an ADS connector.
Solution 1: Modify the interface setting.
Reason 2: The data transmission failed when sending (e.g. short circuit in the line).
Solution 2: Get rid of the short circuit, for example.
Reason 3: Connector not connected or no power supplied.
Solution 3: Check whether the connector is connected and is supplied with power.
Reason 4: The device manager has been used to disable the FIFO buffer for COM1.
Solution 4: In the device manager (Windows XP: Enter “Start” à “Control Panel” à
“System” “Hardware” “Device Manager” Ports (COM & LPT)), and then
select COM1 from the ports. Then under the “Port Settings” tab, select
“Advanced”. There must be a check-mark by “Use FIFO buffers” and “8” must be
selected for the receive buffer and transmit puffer.

Interface USB OBD2 for BMW - INPA/Ediabas - K+DCAN allows full diagnostic of BMW from 1998 to 2008 (all function as in OMNITEC interface). Build in 2 lines K and D-Can magistral

vargstu toliau su savo kabeliu. su w7 64 bitu nieko nesigauna, ant xp paleidau, su keliom inpom, rodo ir baterija, ir degima, galiu prisijungti prie automobilio, tik ne prie visu bloku. prie klimos, variklio neiseina, nors darant klaidu nuskaityma dde figuruoja sarase. atidariau kabeli, pin 8 isvis nepajungtas, noriu tiketi kad ji nereikia trumpinti su 7 pinu, kad jis nereikalingas 2008 metu automobiliui.
stai tokias klaidas gaunu: yra minciu?